sparkysx

Cheers, I'll have to retro fit the wheels and see if they are in the same place as the wheels that came with it.

Just got one of these today, looks like a nice buggy and I have the ansmann x2c pro aswell. My question is, it has 14 hex's and I have lots of new 12mm hex wheels that I want to run, are there any 12mm hubs available that will fit this? thanks!

Are most of those spares for the nitro version?

I like it, I almost bought one new but ended up buying a 2nd hand Trophy buggy flux, that's gone now aswell.

2s lipo is like nimh with nos, I'll nevergo back to standard batteries, and looking after them isn't a big deal at all.

Modelsport confirmed it was faulty and issued a credit, I then went and bought another one exactly the same from Modelsport, it's still a good powerful charger, and the odds of me getting another duff one would definately in my favour.

At the worst the cells read 3.79 and 3.80, normally both matched exactly though. I have it set at 5.0amps 7.4v 2s. Modelsport are going to have a look at it. It does the same thing on 4 seperate batteries, 2 of the batteries are only a few days old. Oh, and this is on two different cars aswell.

This is with a 2s, hour for the cells to read 4.20v then another 30 mins or so until it beeps...

5000/2s/60c lipos, 60mins plus from storage

Mines taking a stupid amount of time from storage, over an hour. Just got the charger back from Modelsport because the fan sounded like a hoover, but will phone them tomorrow about the charge times. I have 2 brand new turnigy's and 2 older dynamic lipos and they all take a really long time to charge. The charger is this one:- http://www.modelsport.co.uk/overlander-rc6-vsp-80watt-7a-output-ac-dc-charger/rc-car-products/379060

How long is it supposed to take to charge one, 5000/2s/60c? cheers

My lipos get to 4.20v per cell quite fast, but then it's ages until the charger beeps that it's done.

Is it nessasary to always balance charge lipos? It takes much longer. Cheers

I've had tyres stuck to my hands using the thin stuff, I just grit my teeth and twist them off!

going to go with your ratio, but 60k in the middle as its a bit cheaper :S