Mitrab36

A well known fact in local authority circles, everyone is eventually promoted the their level of incompetency !!!!

I'm sure I've seen a few of his works at 'Brick' @ the NEC a couple of years ago. Very clever.

Lol... had a bit of ooops moment?

Bump.

It's ok, your with friends here, there's no shame in admitting you haven't got the minerals to just tell her straight !!! Although I think asking for hop up's and goodies for a fictitious 5ive, might spoil the surprise element in you plan somewhat dear Sully !

Bump. Open to offers and swaps!

Oh dear I feel another KM / clone parts bashing thread starting......

Your talking about the isolator for the carb yeah? So essentially the inlet manifold. First thing to do is work out exactly where the fault is instead of throwing new gaskets at it and overtightening bolts. Easy to do with a steel ruler and a torch or even just the isolator block. Hold it up tight and where the light leaks you have a gap !!! simples. This will tell you which one of the faces has a high or low spot. Then with some wet & dry on a little block of MDF you can lap the faces to meet perfectly. Then fit the isolator on it's own on the head lightly and check with the torch again. It was quite a common thing to do with 2T race MX engines where a perfect seal is essential. Remember the parts your fitting together came from 2 different factories, so although it would be nice if they fitted first time, in reality tolerances have to be allowed for. Sounds like a lot of work but unless the new head is properly warped should only take about 30mins to do. If there's a massive gap then you just got unlucky with a bad head and they should exchange it.

Bump. Now lowered to £250

Bump

Bump

Bump!

Hi gaz. Trades for 1/5 baja hop ups could be tempting. I tried to edit it 3 - 4 times. looked perfect. Hit post and it had a fit !

For sale is my Crawler. Axial Dingo body with full working front and rear lights (on Ch3). Scout axles and running gear, Hw 1060 waterproof esc. Integy BEC running steering and lighting. Integy servo switch to control lighting. 4 wheel steering enabled (can be removed if buyer requests). Axial shocks. Alloy servo arms. 1 off all alloy chassis including billet transmission mount, chassis braces, rock sliders, front and rear bumpers, battery tray & ESC tray. Adjustable alloy suspension links all round. Comes 100% ready to run with all electrics, Tx, Rx fresh batteries in the TX and a zippy 5000mah 2s lipo. Collection prefered (West Mids). £250 + postage .