Rc lari

Hi can people help please? I've recently bought a new lowride pumpkin kit and found the gear bearings don't fit as the originals and the new sealed ball bearings I bought just fall straight out , I even bought the reinforced gear assembly but just the same!!.... I've contacted the supplier and they just said call tamiya, a bit pants customer service really..!! Also I'm after some hop ups and some oil filled shocks/dampers but can't find any for the M-06 just m-05 / M-03. If anyone can help that would be grateful. ?

Sold mine. Needed money [emoji22]

Nice!!

I used a hot gas soldering iron at work so I just use that just make sure it gets really hot so its a touch and go job. So not to heat the motor connectors to much

I've now got the ezrun 120a 4000kv setup with p/card £89 works really well

I had this issue with mind the stock emh3s ESC is ment to be water proof but its not very.... Best thing to do is disconnect the fan if possible remove from car and dry out on a radiator... Once dry rebuild and recalibrate.. Also make sure you dry/ get water out out the motor. I got loads in mine... To the point I blow hard into the motor output shaft end hard and managed to force water out the wires... The same the other way around. Even then the motor siezed up and I had to strip it down and try and free up the bearings it should come back to life when it's all dried out OK. Mine is in my new Sakura d4 drifter work great.. Good luck

Very true.. Using the Velcro can be a fuse to set up each time could always use magnets they should be easier each time and should self align

Looks spot on

Nothing today

Pictures ..... Or it didn't happen!! You know the rules lol

Yep my way also!!!! Hmmmm is your way the same as my way.......[emoji189]

Good luck its a bit crazy lol... I've put mine on Max then turned it down about half way otherwise it doesn't want to drift lol

That's how are very got my battery at the moment hanging out its arse.... Don't seem to get much front grip now... [emoji22]

Thanks buddy Setting up the stealth mods was really easy to be honest

Where did you mount the battery housing?