I have a hyper 10 with a force 15 engine i have noticed. That it don't have a lsn on the throttle. Side
Sent from my RM-914_eu_euro1_280 using Tapatalk
I have tryed it just cant seem to get it rite i get it to idle fine then when a open it up full throttle. It cuts out t
So a start doing the hsn then it sends the idle off slightly lol
Sent from my RM-914_eu_euro1_280 using Tapatalk
Hi is a one that can help me out that i can go to or thay can come to me and help me tune my car i just cant master it im in Warrington
Sent from my RM-914_eu_euro1_280 using Tapatalk
Its been set to factory setting but had to open hsn a bit to keep it running but its ok opening it up but soon as fully open it just cuts out cant be the glow plug as had new one in today
Sent from my RM-914_eu_euro1_280 using Tapatalk
Hi all can anyone help i have a hyper 10 with a force 15 engine. Im having a bit of a problem with. When its running and i open it up full it cuts out not sure why can someone. Help me out with what to do pls
Sent from my RM-914_eu_euro1_280 using Tapatalk
Well by this time tomorrow. I should have my 1:10 hyper 10 up and running from the dead fingers crossed
Sent from my RM-914_eu_euro1_280 using Tapatalk
Hi im looking for a hyper 10 Central breaking system or the pads to replace. The ones on my hyper can anyone point me in the rite place to look cant see anything on tbay
Thanks in advance
Like me then all looks good on the car just the ll
Elc what did u use to clean it i have some degreaser. A was g a use but don't no if be safe
Sent from my RM-914_eu_euro1_280 using Tapatalk
A can turn the nut where the pullstart is and see the piston go up and down and hear a pop sound when do it so don't think its seized. Up
Sent from my RM-914_eu_euro1_280 using Tapatalk