Ryanmorrison92

Evening all, After leaving my scx10 in the shed for over a year I had to strip it down and rebuild. One problem is that the hardware is mostly rusted. I'm having a hard time finding a complete screw kit to replace them with.

Im wondering if i can make a gimbal holding a GoPro invert 90 degrees so i can film and also take photos from above ?

Hi there, I'm looking to build a bigger drone but not sure what board i would need to make it hold position in the air, I've only been flying 250mm any help appreciated.

Hi there, Ive been flying 250mm drones for fun for a few years now. Im now after building a 450mm drone that i can use for aerial photography so i would need to have some sort of GPS or telemetry, I'm not sure what board i would need for this project any help welcome

I have a Taranis bound to my x4r I ordered another to use via my cc3d board but the port does not work how can I get over this. Sent from my iPhone using Tapatalk

Hey there all I'm looking to upgrade my radio gear for my drones. At the minute I have two 250mm and a 450mm I would like good range for some FPV flight. Any suggestions welcome. Sent from my iPhone using Tapatalk

Cheers I sure will Sent from my iPhone using Tapatalk

Hey there all I have been given a boat but I know nothing about this side of the hobby. It has no electronics and a very small Motor I need a new propellor and internal prop shaft. I will upload some photos and hello or advise would be much appreciated. The motor and the prop shaft where connected using a thin rubber heat shrink type stuff is this recommended ? Sent from my iPhone using Tapatalk

Well done. Looking forward to a new running video Sent from my iPhone using Tapatalk

Afternoon all just been reading through the thread while stuck on the M1 in traffic, on way to gatwick airport. Very good read a lot of information. I have had a 3Racing Sakura D3 for about 18months, it's totally stock and I have only used it on car parks. I want to get into a little more drifting. Is the D4 RWD a better rig as I'm not really a fan of all this CS ratio. Sent from my iPhone using Tapatalk

I am recently having a few problems with my drones, 250mm racer and dji450. I have a flysky FS-T6. I get less than 100M away and it starts to delay in responce or one side of the motors die flips over then comes back to life upside down.

I have a 250 e-max quad with an open-pilot board in it. I have had nothing but trouble with configuring it, I seem to get so far and the programme just dosent want to work anymore. Is there any other programmes that can help me out ?

any links would be helpful nothing to heavy

any links would be helpful nothing to heavy

any links would be helpful nothing to heavy