scoony191

Anyone know what rod ends I need to fit my fg alloy rear hubs mine are to thick to fit in between hub housing any help thanks

Flip I'm not sure now did the top ones have the pins with e clips to secure them to the bottom arm

Yeah the second is the ones I had but my rod ends didn't fit in between for some reason

Can post one later I'm on my phone at the min just been looking at some others and it looks like there is some sort of adaptors to add on to make them fit

Hi just purchased some rear alloy hubs off eBay for my marder but the rod end does not fit in for some reason just wondering if something is missing any help thanks

Just put a new pipe on do I need to tune anything on the carb settings its running ok any views on this thanks

Ahaaaa I'll try that cheers

Hi all asking this question for a friend I don't know a lot about engine problems/trouble, when he seems to srart it it doesn't seem to tick over but if he catches it right he can drive around but when it stops it just dies any ideas thanks

Going to send them back not happy with them where could I buy a new set from

Going to send them back not happy with them where could I buy a new set from

There is no springs in the cup and did not come with any

Hyper did you manage to sort out the size of the shafts for you set up if so what size did you end up with thanks

There is no springs in the cup and did not come with any

Checked all sockets they are the same size as my old dog bones, do these ball drives need to be butt up hard or just to where they need to be there is no zip ties around the rubber boots do they need them as they slide in and out and that's what is causing the hit and miss when in drive

I'm not a 100% I am going to check to be certain I have a feeling they are going to be to short, will let you know my finds in the next hour or so