lilllad83

Ok guys still have this engine, decided to run it at my last meeting on Sunday and the old girl got me qualified 5th in the A final! Surely a testament to the os build and design quality!!! I would still like to rebuild her with new liner piston and crank so can anyone point me in the right direction for the parts please? Had a test repinch done on a lesser engine after my original post but the engine never performed the same so am reluctant to try this on the os as she's still a screamer! Just want the run time and precise tune back .. Any help appreciated thanks

Very tempted

http://rcpitbox.myshopify.com/products/ielasi-tuned-itd-21-4cq-square-stroke-21-4-port-competition-buggy-engine/ opinions please? Was projecting 14 min runtimes at the neo16 after just being ran in round Ledbury the week before which it gave 11.5 min runtimes flat out!

Is that jar of sugar 1/10 or 1/8 scale!?

Parcels built up this week as busy at work.. Gt12 1s lipos gt12 motor and esc gt12 bearing set ceramic lipo & life receiver batts x2 hv 1268sg servos for xb8 1256tg servo for desc210 shoe goo 410 receiver p5 novarossi an pipe 10 plugs bearing sets for xray xb8 and xb9 Drive shafts all round for xray xb8 Cv rebuilds all round Bag of anti roll bars for xb8 4mm bullets 14awg cable receiver voltage monitor Lipo/usb charger thing (dead handy) centre diff bulkhead xb8 spur xb8 clutch setup jvd clutch bell Xb8 Shock bush sets x3 xb8 piston set 10m fuel tube pink clutch bearings x20 starter box peg set starter box switch An arsy letter from the bank Busy weekend ????

Change ur connectors oxidisation has probably built up making a weak join, happens to my revo every few months. If your cells are ok and ur esc ain't thermalling it must be the connectors :-)

If the receiver works u can get the esc apart, do so it won't hurt trying to dry it out

Take the receiver out, open it up and warm with hair dryer, look for obvious moisture. If you have a hump pack try powering up the receiver with a servo to see if it works, try both channels obviously. Think if it was the esc you would still have steering unless it proper ****ed it

Got a desc210 with servo for sale, 2 bodies and a few wheel sets for

Can I take the hudy handles lot please

I'll take the 1256 pls m8, what's ur PayPal

Need to drill some new holes so i can sit the XB9 on with four pegs, as i'm using the fronts only at the moment.

Since this time last week the postman has been busy.. X-ray xb8 2015 (tired of my Kyosho breaking) Full spring set High def brake kit Spare shocks Clutch bearings X-ray hoody Hudy hat X2 1256 servos Spare drive train parts Shaft pins Air filters and oil Proline pin points rims and insets Answer x 4 clutch shoes Answer x3 clutch shoes Gallon of rb fuel Glow plugs Selection of Pistons Silicone oil and finally an overdraft warning from the bank :-0

Think ur Inbox is full m8