I was looking at some tractor pulling trucks, thought it would kool to make one, I using a king hauler cab scratch built bed parma motor kit 5700kv brushless system rc4wd r2 trans rc4wd force alum rims lesu tires rc4wd lockable axles alum rear bumper
I made a bracket for the belly to mount to the rear section, its made from 1/4 inch alum bar , also mounted the rear bumper , its from the king hauler kit
working on the flip extension, works really good, don't let the plastic fool you, its wrapped arround solid 1/4 inch alum bar. also instead of wooden planks, I went with a antislip tape, really nice stuff
I was looking to do something more towards a show then work trailer. rc4wd sells black and red blank rails this will be a tandem with rear flip axle, also will have a flip extension goose neck . will be making a jeep / dollie too
next I wanted to see how high I need to make this sit with a no load . I use 2x channel to sit under the belly . then I used a dollie up front, same as truck. leveled it out I cut the hinges for the fold down
lets get started on the belly of this beast . I need end pieces for the each end of the chassis so I used the front bumper mounts of the king / globe trucks to scale the belly is 25 1/2 inches long and 7 inches wide the c-channel is from online, 22mm high x 6mm wide next I cut the metal for the front deck. this is 11 inches long