ESC calibration

[Gil]

I'm changing motor on my Losi truggy, do I need to re-calibrate the esc?

Or should the first throttle calibration still be good? I'm using the same transmitter, ESC,servo, batteries...

Edited March 3, 2015 by Gil

[evssv]

I'm changing motor on my Losi truggy, do I need to re-throttle calibrate the esc?

Or should the first throttle calibration still be good? I'm using the same transmitter, ESC,servo, batteries...

no need to change it....what motor did u end up with?? Edited March 2, 2015 by evssv

[Gil]

A Absima 2300kv from a friend.
Did not buy it , is borrowed for me to experience.
Is shorter than my ...

[evssv]

A Absima 2300kv from a friend.

Did not buy it , is borrowed for me to experience.

Is shorter than my ...

don't kill it....lol!! Edited March 2, 2015 by evssv

[Gil]

Why? It's from a Team C truggy.

I just have to do other's extensions with 6mm plug to fit in my ESC

[evssv]

Why? It's from a Team C truggy.

I just have to do other's extensions with 6mm plug to fit in my ESC

jus kidding mate!!...normally when people borrow anything off a mate it normally goes wrong or sumin happenes to it...

[Gil]

It's true evssv  

I tested it today and I don't think the problem is in the motor.

what settings in DS3X travel and punch should I use?

[HYPER-BOY]

For calibration I thought everything was supposed to be at neutral? Zero values all round.

[Gil]

For calibration I thought everything was supposed to be at neutral? Zero values all round.

But I need re-calibrate it?

[HYPER-BOY]

But I need re-calibrate it?

Wouldn't hurt to see if it makes it better

[Gil]

Wouldn't hurt to see if it makes it better

Ok, it's easy to calibrate so why not try...

[HYPER-BOY]

Ok, it's easy to calibrate so why not try...

Just make sure the TX values are zero (middle) !